| Availability | In Stock |
|---|---|
| Condition | Brand New |
Multiple current/RDM/Stand-alone function/Seven PWM frequency/Linear or logarithmic dimming/Numeric display
● DC to DC constant current output, multiple output current settings.
● Comply with the DMX512 standard protocols.
● Digital numeric display, set DMX decode start address by buttons.
● RDM function can realize intercommunication between DMX master and decoder. For example, DMX decoder address can be set by DMX master console.
● 1/2/4 DMX channel output selectable.
● 16bit (65536 levels) /8bit (256 levels) grey level selectable.
● PWM frequency 250/500/1000/2000/4000/8000/16000Hz selectable.
● Logarithmic or linear dimming curve selectable.
● Stand-alone RGB/RGBW mode and 4 channel dimmer mode selectable, which be controlled by buttons with built-in programs, instead of DMX signal.
● Green terminal, XLR3 and RJ45 port DMX signal input.
Standards and Certifications
D4C-XE 
1. The LED quantity at each channel can be different, the decoder could auto-check and output a proper voltage to each channel according to its LED quantities.
2. The decoder works on buck mode, the voltage of the power supply should be greater than the total voltage of the series LEDs.
3. If connected with a single color LED, and the decode mode set as 1 channel decode, the output current can be 700, 1050, or 1400mA when connecting 2,3 or 4 channel, but the multiple LED output- can not be connected together, otherwise, result in an error output current.
4. An DMX signal amplifier is needed if more than 32 decoders are connected, or use an overlong signal line, signal amplification should not be more than 5 times continuously.
5. If the recoil effect occurs because of a longer signal line or bad line quality, please try to connect 0.25W to The 90-120Ω terminal resistor at the end of each DMX signal line.
