10mm 4Pin solder-free stripping buckle waterproof IP67 connector hippo buckle board to wire suitable for RGB casing LED Strip Light

IP67 Waterproof Seal

Provides complete dust and water protection, making it perfect for outdoor, landscape, and damp location installations.

Solder-Free 'Hippo' Connection

The clamp-down buckle pierces the strip's waterproof casing and wire insulation, creating a strong mechanical and electrical bond without any soldering.

Board-to-Wire Design

Perfect for starting a lighting run by connecting your 10mm 4-pin RGB strip directly to power wires.

Designed for Cased Strips

Uniquely engineered to work with RGB LED strips that are enclosed in a silicone or plastic waterproof casing.

Secure & Reliable

Built from durable polycarbonate to ensure a long-lasting, stable connection that resists vibration and environmental stress.

Outdoor & Landscape Lighting Create durable, weatherproof connections for waterproof RGB strips used in gardens, pathways, decks, and patios. The IP67 rating ensures reliable performance in rain, snow, and humidity.

Bathroom & Kitchen Installations Safely connect under-cabinet, vanity, or cove lighting in moisture-prone areas. The sealed connector protects against splashes and steam, preventing corrosion and short circuits.

Architectural & Facade Lighting Ideal for professional installations on building exteriors. The secure, solder-free design simplifies on-site wiring and guarantees long-term connection integrity against the elements.

Marine & Poolside Ambiance Use this connector for accent lighting on boats, docks, or around pool areas. Its robust seal protects against saltwater spray and splashes, ensuring your lighting stays vibrant and safe.

⚠ Precautions

• Double-check that the polarity (+, G, R, B) on the strip aligns with your power wires before closing the buckle.
• This connector is specifically designed for 10mm 4-pin RGB strips with a protective waterproof coating. It is not recommended for non-waterproof (IP20) strips.
• To maintain the IP67 waterproof integrity, ensure the connector is fully snapped shut on all sides.
• The connector is intended for a one-time, permanent installation. Reopening and closing it may compromise the waterproof seal and the piercing contacts.

Q: Do I need to strip my wires before using this connector?

A:No. This is a key feature. The connector has insulation-piercing contacts that make the connection when you clamp it shut, saving you time and effort.

Q: Is this 4 pin rgb connector reusable?

A:We recommend these for single-use, permanent installations. Reopening the connector can damage the piercing pins and compromise the IP67 waterproof seal.

Q: Can I use this to connect two LED strips together?

A:No, this specific model (RGB-ACCESSORIE-031) is a board-to-wire connector, designed to connect a strip to a power source. We offer separate strip-to-strip connectors for joining two segments.

Q: Will this work with an 8mm wide or 12mm wide strip?

A:No, this connector is precisely engineered for 10mm wide 4-pin RGB LED strips. Using other sizes will result in a poor or non-functional connection.

Q: How does it remain waterproof after connection?

A:The connector features a tight-clamping housing and is often filled with a silicone gel that completely encases the connection points when closed, blocking out all moisture and dust.

Q: Can I use this on a non-waterproof (IP20) LED strip?

A:While it might make an electrical connection, it's not ideal. The piercing pins are designed to go through a silicone casing, and the fit may be loose on a bare strip, leading to an unreliable connection.