EM3 Microwave Two Steps Dimmable Motion Sensor Switch - Replaced By EM

Replaced by EMR. 

 

● Active microwave motion detectors with HF system 10.525GHz, motion can be detected through plastic, glass and thin non-metal materials.

● Built-in motion sensor and daylight sensor.

● Powered by low voltage 9-24VDC, output 5V level or PWM signal.

● Detection area, time delay and daylight threshold can be set via knob potentiometer for each specific application.

● Wide detection area, range up to 20m in diameter.

● Support higher mounting height 15m Max.

 

Technical Parameters

Working voltage: 9-24VDC

HF system: 10.525GHz

Power consumption: < 0.5W(Standby) , <1W(Operation)

Detection zone Max.(DxH): 20 x 15m

Detection sensitivity: 10%/25%/50%/75%/100%

Hold time: 10s/30s/90s/3min/10min/20min/30min

Daylight threshold: 10lux/30lux/50lux/100lux/150lux/200lux/Disable

Mounting height: 15m Max.

Motion detection: 0.5-3m/s

Detection angle: 150°(wall installation), 360°(ceilling installation)

 

This sensor is a motion switch with two-step dimming function, which turn on the light upon detection of motion, after a pre-selected hold time,

dim to 20% brightness, and turn off after a pre-selected stand-by time when there is no movement.

 

1. With sufficient ambient light, the sensor does not turn on the ight.

2. With insufficient ambient light, the sensor turn on the light and dim to 100% brightness when motion is detected.

3. After elapse of hold time, the sensor dim to 20% brightness if no new motion detected.

4. After elapse of stand-by time, the sensor turns off the light if no motion detected.

 

Specifications Download    

Standards and Certifications