4-Pin SMD Waterproof RGB LED Strip Connector Wire for 10mm/12mm PCB

Create seamless, water-resistant connections for your custom lighting projects with the SuperLightingLED Waterproof RGB LED Strip Connector. This 4-pin, solderless connector is expertly designed to join cut sections of 10mm and 12mm waterproof RGB LED strips, eliminating the difficult and time-consuming task of soldering wires to coated strips. Its insulation-piercing contact system creates a secure and reliable electrical connection by piercing through the protective silicone coating. This makes it an essential tool for contractors and DIY enthusiasts installing outdoor landscape lighting, bathroom accents, or any application where moisture is a concern. Achieve professional, durable results without the hassle of stripping coatings or soldering in the field with these essential connectors.

Technical Highlights

• Insulation-Piercing Contacts: Four sharp copper pins ensure a direct, low-resistance connection to the strip's solder pads.
• Secure Locking Mechanism: The two-part housing snaps together firmly, applying even pressure to maintain the seal and secure the strip.
• Durable Housing: Made from high-clarity, impact-resistant polycarbonate (PC) that withstands UV exposure and temperature changes.
• Visual Confirmation: The clear top allows for easy inspection of pin alignment and successful connection before final sealing.

1. Step 1: Prepare the Strip: Cut your waterproof LED strip cleanly along the designated cut line.
2. Step 2: Insert the Strip: Open the connector. Slide the end of the LED strip into the transparent housing part, ensuring the copper pads align with the pin locations.
3. Step 3: Assemble the Connector: Place the transparent housing (with the strip inside) onto the connector base. Ensure the side with the small guide holes faces down towards the base.
4. Step 4: Secure the Connection: Using pliers or firm thumb pressure, press the transparent housing down until it snaps securely into the base. You should feel the pins pierce the strip.
5. Step 5: Verify Connection: Visually inspect through the transparent top to confirm the four pins have fully pierced through to the copper pads on the LED strip.
6. Step 6: Test: Connect your strip to the power supply and controller to test the connection before final placement.

⚠ Precautions

• Designed specifically for waterproof strips with a top-layer coating; not suitable for non-waterproof (IP20) strips.
• Ensure your strip is 4-pin LEDs, RGB or addressable dual-signal lights. This connector is not compatible with 2-pin (single color), 5-pin (RGBW), or 6-pin (RGBCCT) strips.
• For best results, use on a flat, clean-cut end of the LED strip.
• While designed for a strong connection, it is recommended to limit use to one connection attempt per connector end to ensure pin sharpness and integrity.