| Availability | In Stock |
|---|---|
| Condition | Brand New |
This TM07E controller has been discontinued, please check out the Mi-Light P2 LED wall panel controller for replacement.
Touch panel controller is a new high-end controller which newly developed by our company. It adopts glass panel design, is beautiful and fashionable in appearance. It adopts high precision capacitance touch control chip, increases the touch sensitivity, reduces trigger which caused by mistake. It is used for controlling a variety of lamp whose source of light is LED. For instance, point source of light, flexible light strip, panel lights etc., it has many advantages such as convenient to connect, easy to use and others.
Technical Parameters
● Working Temperature: -20-60℃
● Power Supply Voltage: DC 12 to 24V
● Output Voltage: DC 12 to 24V
● Output: 2 circuits
● Connection Method: Common anode
● Dimensions: L80 x W80 x H41.8 mm
● Packing Size: L110 x W110 x H56 mm
● Net Weight: 128g
● Gross Weight: 215g
● Waterproof rsting: IP65
● Static Power Consumption: <1W
● Output Current: <4A (each circuit)
● Output Power: DC12V: <96W, DC24V: <192W
Specifications Download 
External Dimension
Interface description
"1", "2": power input pin, the input voltage range is 12-24V, "1" is negative, "2" is positive;
"3", "4", "5": power supply output pin, output voltage is 12-24V, output maximum current is 4A, "3" is positive, "4" is a cold-color lamp interface, "5" is a warm-color lamp interface.
Instructions
Key function description
:Brightness plus, there are 80 levels
Typical Application
Installation method
1. Wiring
Wiring according to typical application circuit. Refer to the typical application circuit.
2. Open the touch panel
① As shown in the figure, use a "one" screwdriver to gently pry at the notch of the touch panel to remove the panel;
Install the switch base
As shown in the figure, after connecting the wires, install the touch controller in the wall cassette, then screw it to fix it on the wall, and install the base on the wall.
4. Cover the touch panel
Optimistic about the direction of the panel, cover the panel as shown below:
Remarks
1. Connect the load wire at first, following by the power wire; Please ensure short circuit can not occur between connecting wire before you turn on the power;
2. The supply voltage of controller ranges in DC12-24V, it may burn out the controller once exceed the voltage.