| Apply to: | 16*16mm Neon Flex (Base), 12*10mm Neon Flex (Base) |
|---|---|
| Availability | In Stock |
| Condition | Brand New |
The 2-pin solderless power pigtail cable provides a reliable electrical supply line directly to cut-anywhere LED neon strip lights without requiring soldering equipment or stripping delicate internal neon conductors. Engineered specifically for continuous-cut single-color neon profiles featuring top-surface PCB solder pads, this power cord cable pigtail integrates rigid internal copper contact prongs inside a low-profile molded head.
Pressing the connector head firmly onto the neon end creates direct, mechanical surface pressure against the copper pads, establishing low-resistance continuity in seconds. The attached 1.5-meter (4.92-foot) transparent parallel 22 AWG power pigtail cable wire maintains an unobtrusive appearance across cabinetry, furniture reveals, and architectural coves, while stripped and pre-tinned bare leads on the opposite end allow direct connection to a terminal block, controller, or power supply.
Internal conductive copper prongs mate directly with exposed PCB pads on cut-anywhere LED strip lights, removing the need for a soldering iron or heat guns.
Provides 150 cm of 22 AWG parallel cabling between the illuminated profile and your driver, reducing the need for intermediate in-wall splice points.
Clear parallel jacket conceals wiring within open shelving, custom retail showcases, and light-toned furniture millwork.
Stripped ends feature solder-dipped copper stranded wire to eliminate fraying inside terminal blocks, lever nuts, or screw-down power terminals.
Symmetrical mechanical head layout enables positive and negative DC orientation based simply on connector insertion alignment.
| Parameter | Details |
|---|---|
| Model SKU | NEONACC-2P-150CM-SSC |
| Product Type | Solderless Power Pigtail Cable for Cut-Anywhere Neon |
| Conductor Count | 2 Conductors (Positive / Negative DC) |
| Wire Gauge | 22 AWG (Stranded Copper) |
| Cable Total Length | 1.5 meters (1500 mm / 59.05 inches) |
| Input Termination | Stripped and tinned copper wire leads |
| Output Termination | Proprietary snap-on surface pad contact plug |
| Strip Contact Style | Top-surface PCB pad mechanical pressure prongs |
| Supported LED Strip Type | Cut-at-any-point (cut-anywhere) 2-wire LED neon strip lights |
| Operating Voltage Range | 5V DC, 12V DC, 24V DC |
| Polarity Configuration | Determined by LED strip orientation (+/- alignment) |
| Wire Jacket Color | Clear / Transparent |
| Jacket Material | Extruded flexible PVC |
| Ingress Rating | IP20 (Indoor connection point; requires sealant for IP65/IP67) |
⚠ Precautions
Q: Will this power pigtail cable fit standard flat LED strip lights?
A: No, this connector is purpose-built with surface contact pins tailored for cut-anywhere LED neon profiles with surface pads, and is not physically compatible with open 8mm, 10mm, or 12mm flat ribbon LED strip lights.
Q: Is soldering required to attach this power cord cable pigtail?
A: No soldering is required; internal spring-tempered contact pins create instant mechanical electrical contact against the neon PCB surface pads when pressed into position.
Q: Can this power pigtail cable wire be used outdoors?
A: The connector assembly itself is rated IP20 for indoor dry locations, but can be used outdoors if the joint is completely sealed with neutral-cure electronic silicone sealant and wrapped with adhesive-lined waterproof heat-shrink tubing.
Q: How do I know which transparent wire is positive and which is negative?
A: The two conductors are clear parallel wires; simply trace the physical wire path from the connector head down to the bare leads to match whichever contact pin lands on the (+) and (-) pads of your LED neon strip light.