| Availability | In Stock |
|---|---|
| Condition | Brand New |
The MiBoxer TRI-K1 is a line-voltage rotating triac dimmer switch engineered for trailing edge phase-cut brightness adjustment across AC 100-240V electrical systems. Delivering up to 1.36A output current (150W at 110V or 300W at 220V), this compact 86x86mm wall unit replaces mechanical switches to control dimmable LED drivers, incandescent fixtures, and line-voltage architectural illumination. It pairs rotary physical adjustment with 2.4GHz wireless reception, communicating seamlessly with secondary remotes and auto-forwarding signals to adjacent dimmers within 30 meters.
Applies electronic reverse-phase (ELV) control for smooth 0% to 100% stepless dimming without audible buzz on compatible loads.
Rotate the dial for immediate brightness selection or push once to toggle circuit power on and off.
Configurable minimum dimming threshold prevents low-end lamp dropout and startup flicker.
Receives signals from controllers within 30m and relays commands to adjacent units for extended installation coverage.
Internal temperature detection switch and overload circuitry safeguard against excessive thermal build-up and current surges.
Allows locking out dimming operation via 5-press button sequence to function strictly as a non-dimming mechanical bypass switch.
| Parameter | Details |
|---|---|
| Product Model | TRI-K1 |
| Product Type | Rotating Triac Dimmer (2.4GHz) |
| Input Voltage | AC 100-240V, 50/60Hz |
| Output Voltage | AC 100-240V |
| Output Current | Max 1.36A |
| Output Power (110V) | 150W @ 110V |
| Output Power (220V) | 300W @ 220V |
| Dimming Technology | Trailing edge phase-cut (ELV) |
| Dimming Range | 0% to 100% stepless |
| Wireless Protocol | 2.4GHz RF |
| RF Control Distance | 30m (open area, auto-transmitting mesh) |
| Compatible Load Types | Triac dimmable LED fixtures, incandescent lamps, halogen lamps |
| Internal Protection | Over-temperature detection, overload shutdown |
| Ingress Protection | IP20 (indoor dry locations) |
| Operating Temperature | -10°C to +40°C |
| Housing Material | Flame-retardant PC |
| Panel Dimensions | 86mm x 86mm (front plate) |
| Installation Depth | 48mm back diameter; 22mm / 9mm / 17mm segment profile |
| Certifications & Compliance | CE, EMC (EN 301 489-1/-3), LVD (EN 61347-1/-2-11, EN 62493), RED (EN 300 440) |
Q: can you use a dimmer switch on led lights
A:Yes, provided the LED fixture or LED power driver is explicitly labeled as phase-cut or triac dimmable. The TRI-K1 uses trailing edge dimming technology specifically matched to modern electronic LED loads.
Q: can you put a dimmer switch on led lights that are non-dimmable
A:Non-dimmable LED drivers should not be dimmed, as doing so causes buzzing, flashing, and premature driver failure. However, you can set the TRI-K1 into 'Breaker Mode' (5 rapid clicks of the SET button) to use it strictly as an on/off switch without dimming output.
Q: How does the 2.4GHz auto-transmitting function operate?
A:Each TRI-K1 dimmer receives RF instructions from paired remotes and automatically forwards the commands to other dimmers within a 30-meter radius, creating an extended relay chain across large rooms.
Q: Do I need a neutral wire to install the TRI-K1?
A:Yes, the TRI-K1 requires dedicated AC line (L) and neutral (N) input connections to power its internal 2.4GHz RF module and microprocessor circuitry.