IP68 LED Strip Lights For Pools

An IP68 rating means the strip is completely dust-tight and protected against long-term immersion in water under pressure. Our IP68 LED strip lights for pools achieve this through a solid silicone extrusion or potting process. This fully encases the circuit board and LEDs, leaving no air gaps for water to penetrate, which is critical for safety and longevity underwater.

The main trade-off between a 12V and 24V pool light system is run length versus cut-point resolution. A 12V swimming pool light strip typically has cut points every 25mm or 50mm, letting you get a more precise fit. However, 24V strips can run much longer—often 10 or 15 meters—from a single power feed before voltage drop becomes an issue. For most full-pool perimeters, 24V is the more practical choice.

Honestly, no adhesive is permanent underwater, especially with pool chemicals. The included double sided tape is for positioning the strip during installation. For a permanent, reliable installation of any underwater LED light strips, you must use the included silicone mounting clips at regular intervals. We recommend a clip at least every 12-18 inches.

The most common failure point we see is water getting into the connections. If you cut and reseal an IP68 strip on-site, that seal has to be perfect. The other frequent cause is using a strip that isn't rated for the chemicals in your pool. Chlorine or saltwater can degrade lower-quality silicone or PVC jackets over time, leading to cracks and water ingress. All our IP68 strips are tested for this.

Yes, they are designed specifically for these environments. Our IP68 LED light strips use a high-grade, UV-stable silicone that resists the corrosive effects of both chlorine and saltwater. Cheaper strips often use PVC or low-grade silicone that can turn yellow, become brittle, and crack when exposed to pool chemicals, which is a primary cause of failure.

For a full pool perimeter, you'll need to plan your power injection. A typical 24V strip can run about 10 meters (32 feet) before dimming. For a longer run, the best practice is to run power to both ends of the strip from a single, centrally located DC24V waterproof power supply. For very large pools, you may need to power it from the center of the run, splitting it into two separate lengths.

Yes, but you must choose the right model. We have specific sauna-rated IP68 strips designed to withstand high heat and humidity, like our 24V Heat Tolerant Sauna strips. A standard IP68 strip might be waterproof, but the prolonged high temperatures in a sauna can degrade the LEDs and silicone if it's not specifically engineered for that thermal load.

Yes, and this is non-negotiable for safety. Any electrical circuit for a pool must be on a Ground Fault Circuit Interrupter (GFCI). While our IP68 strips are low-voltage (12V or 24V), the power supply itself connects to mains voltage. A GFCI will cut the power instantly if it detects any fault, which is a critical safety layer when you have electricity and water together. Always consult a licensed electrician.

Yes, we do this all the time. A huge amount of what we ship is built to customer drawings. Just send us a sketch of your pool with the dimensions—even a photo of a drawing on a napkin works. An engineer here will map it out, spec the right strip, calculate power, and send back a full parts list and quote, usually the same day. We'll then build the strips to your exact lengths with the IP68 connectors pre-molded for a perfect seal. There's no fee for this service.

You can, but it requires care. After you cut the strip at the designated cut mark, you must seal the end with a non-conductive, waterproof silicone sealant and an end cap. It is absolutely critical that this seal is perfect. For critical projects like pools, we strongly recommend ordering the exact lengths you need from us directly.