Flangeless Recessed Channel Series

Start with your LED strip. Check its PCB width in millimeters—for example, a standard strip is often 8mm or 10mm wide. Your channel's *internal* width must be slightly larger than the strip's PCB width. Then, check the channel's external height and width to make sure you have enough depth and space in your mounting surface (the ceiling joist, the cabinet panel, etc.) to cut the groove.

Definitely. That's a very common application. You just need to route a groove in the wood that matches the outer dimensions of the aluminum channel. The channel should sit snugly in the groove. For a really clean finish, you can use a bit of wood filler along the edges if needed, but often a precise cut is all you need for the channel to look perfectly integrated.

Most of our standard aluminum channels are rigid and designed for straight lines. However, we do have specific bendable models for exactly this situation. We currently list some flexible models in this category which can be shaped by hand to follow gentle curves in walls, ceilings, or custom furniture. For really tight curves, check out our full guide on flexible aluminum channels.

Yes. You can send us your required lengths—down to the millimeter—and we'll cut the channels and diffusers to match before we ship. Just send our engineers a sketch or a list of dimensions; there's no fee for the consultation and you'll get a full quote back, usually the same day.