Magnetic Linear Track Light Strips

A magnetic linear track light fixture is a rigid aluminum module that locks into an extruded rail by magnetic tension while brass leaf contacts tap DC48V bus lines. Permanent neodymium magnets hold the chassis flush inside the channel without mechanical clips or twist-locks. You can snap a fixture in, slide it anywhere along the electrified rail, and remove it by hand while the track is powered, provided you use an isolated class 2 power feed.

A magnetic linear led light strip is a rigid, engineered aluminum fixture with integrated constant-current driver circuitry, while a traditional led tape light track is an empty channel that requires you to stick adhesive flexible LED strip inside. Unlike open tape light track setups where you must solder lead wires and stick diffusers, these magnetic fixtures snap directly into energized 48V rails. That gives you 24W output per module, instant repositioning, and zero messy tape peeling or thermal degradation.

No, led track lighting strips designed for magnetic systems require a dedicated DC48V magnetic channel and will not seat or operate in traditional 120V H, J, or L-type tracks. Our linear magnetic fixtures use internal contact pins spaced strictly for low-voltage magnetic rails, where 48V DC makes hot-swapping completely safe to the touch. If you have an existing line-voltage setup, you must replace the rail with an extrusion from our magnetic track light components and supply it with a DC48V driver.

A floodlight linear led strip light delivers a wide 120° frosted beam for general ambient room coverage, whereas a grille linear fixture uses recessed optical lenses with a tight 24° beam angle to eliminate glare. For instance, our 23.74-inch MF2-24A-RF floodlight bathes wide ceiling surfaces in even light, while an 8.7-inch MG2-10N-RF grille light punches focused lumens straight down onto countertops or art. Grille units keep UGR under 19, so you never get blinded walking under the track.

Calculate your total fixture wattage and size your DC48V driver so continuous load stays under 80% of its rated capacity. For example, if you run six of our 20W grille lights and two 12W flood modules, that totals 144W of consumption. An engineer sizes that load to a minimum 180W driver to prevent thermal shutdown and premature driver aging. 

Yes, you can freely mix linear led light strip modules with spotlight heads and suspended fixtures along the same energized 48V track. Linear fixtures give you general perimeter wash, while units from our sibling magnetic spotlight track lights collection give you rotatable 360-degree accent beams for artwork. Because the bus lines deliver steady 48V across the entire channel, each fixture receives clean power and operates independently via its built-in RF or Zigbee receiver address.

Each fixture features high-grade N52 neodymium magnets backed by mechanical anti-fall locking latches on both ends of the aluminum carrier. The magnetic pull seats the electrical contact prongs against the interior copper bars, while spring-tensioned mechanical tabs lock behind the track profile lips. To remove or slide the module, you depress both quick-release safety buttons simultaneously. This dual-retention engineering satisfies commercial vibration and seismic codes for overhead installations in public spaces.