DC5V LC8812 SK6812 upgraded Built-in IC 60 LEDs 10MM Addressable RGB LED Strip Light, 5 meters/Roll

One data line, two power lines,  built-in IC (4 feet), 256 levels of gray, realized by the controller, gradient, water flow, horse racing, text, numbers, English, pictures, animation, etc. any effect.

1. Control principle: One IC controls one LED to form a loop (a group), and the controller controls the circuit in the FPCB through the control IC to control the different effects of the LED light bar changes; such as flicker, chase, jump, Clockwise horse racing, counterclockwise horse racing, monochrome horse racing, color-changing horse racing, single chase from beginning to end, running water, simulated lightning, etc.; the change effect of this light bar is not limited to the multiple effects built in the current controller, and can be based on customer needs, Write by yourself; it can be displayed in the form of a screen, text, letters, pictures, animation, etc.

2. Environmental protection and safety: It has the characteristics of low power consumption, low heat generation, no glare, and impact resistance. Low voltage DC 5V, high safety, and reliability.

3. Rich and diverse colors can be adjusted arbitrarily through the controller according to customer needs.

4. Long life span: the average life span is up to 50,000 hours.

5. Cutting and welding are convenient and free: each group of LEDs can form a loop, which can be arbitrarily cut along the upper tangent and welded to meet the needs of various light strip lengths required by customers.

6. Soft: The soft FPCB board is used as the base plate, which can be docked, bent, cut, and fixed on the uneven surface at will.

Standards and Certifications

Specifications

Similar to WS2812B LED strip, the SK2812 led strip has 3 wires for sending data - one V+ pin, one GND pin, and one data pin. That means you need 3 pins to control strip. Because the data is separated, you can use any processor speed or type to control these strips. an addressable RGB LED strip is a long flexible strand of LEDs each of which can be individually set to a certain color (hence: addressable). By varying the level of red, green and blue (RGB) per LED many color combinations can be made you can use any processor speed or type to control these strips, you can use any microcontroller or microprocessor, including Arduino, Raspberry Pi, BeagleBone, Propeller, SparkCore, and any 'raw' microcontrollers/microprocessors to control the strip. 

This strip comes as a single full meter with a 3-pin JST SM connector on each end. Every LEDs segment can be cut. Solder to the 0.1" copper pads and you're good to go.you can also connect strips together to make them longer. To power this strip, you need a 5V power supply.