AC110/220V LED Strip Lights

The main advantages of high-voltage LED strips are simplicity and length. You plug them straight into your AC wall power without a bulky transformer, and you can get a single, continuous run up to 50 meters (164ft) ~ 100 meters (328ft). For long architectural outlines, landscape lighting, or large coves, that's a huge time and cost saver compared to dealing with voltage drop on low-voltage strips.

You can only cut a 120V LED tape light at the specific cut marks, which are usually indicated by a small scissor icon printed on the strip's jacket. Be aware that these cut points are much farther apart than on low-voltage strips – typically every 50cm or 1 meter. Cutting anywhere else will damage the circuit for that entire section, and it won't light up.

To connect high-voltage LED strips, you'll use a specific power cord with a pin connector. You line up the sharp pins with the copper conductors inside the strip and push firmly to make a connection. For joining two cut sections, you use a similar pin-to-pin splice connector. Always, always seal the connection and the end cap with silicone glue to maintain the waterproof rating. We stock a full range of high voltage connectors for this.

Flickering in high-voltage LED strips (110V/220V AC high-voltage LED strips) is typically directly related to rectification and filtering, voltage stability, wiring connections, and dimming compatibility.

Choose a 110V LED tape light for long, simple runs where you don't need to make lots of precise cuts, like outlining a building, lighting a long hallway, or in landscape features. Go with 24V for projects needing high precision and short cut points, like under-cabinet lighting, shelf displays, or tight coves where flexible COB strips give you a perfect fit.

Absolutely. This is a huge part of what we do. Many projects need specific lengths that don't land on the standard cut marks. Just send us your measurements—even a photo of a napkin sketch is fine. An engineer here will map it out, figure out the best way to build it, and send you a complete parts list and quote, usually within 12 hours. We'll factory-cut, solder, and seal the strips so they arrive on your jobsite ready to install. There's no fee for the consultation.

To be blunt, the most likely cause is a short circuit or reversed polarity. Unlike low-voltage DC strips which are more forgiving, connecting AC power incorrectly, even for a second, can permanently destroy a section of the strip or the entire reel. Double-check that your power pin is aligned correctly with the conductors and that the connection is fully insulated before you ever plug it in.

An IP67 rated driverless led strip is highly water-resistant, not fully waterproof for submersion. It means the strip is protected against dust and can withstand being temporarily submerged in water up to 1 meter deep. It's perfect for outdoor patios, building facades, and landscape lighting where it will be exposed to rain and splashes. For anything fully underwater like a pool or fountain, you need an IP68 rating and proper IP68 connectors.