DC5V SK6812 3.28Ft 60LEDs Ultra Narrow 0.20in Wide Individually Addressable RGBW LED strip light

The data transmission adopts the communication mode of unipolar return-to-zero code protocol. After the pixels are powered on and reset, the data is input at the DIN terminal, the first pixel IC stores the extracted data in the internal data latch, the remaining data is amplified by the internal shaping processing circuit and transmitted to the next pixel point, but the 24bit signal is weakened after each pixel point transmission, the number of pixel cascade is only affected by the signal transmission speed, the data transmission speed of SK6812 chip is 800Kbps, there is no flicker phenomenon.

The performance of SK6812 driver IC is stable, built-in signal shaping circuit and power-on reset and power-down reset circuits (converting digital signals into analog signals). The IC has high quality , intelligent reverse connection protection, and good LED safety.

This SK6812 addressable LED strip is integrated with SK6812 built-in IC packaged in SMD5050 components, which has a good heat dissipation effect. Both ends of the IC are flush with the PCB to release a lot of space, achieving ultra-narrow 5.5mm/0.22in suitable for a narrow backlight environment lighting. The LEDs are evenly arranged on the PCB, 60 LEDs per meter, lighting the LED strip to produce smooth light.

The addressable RGBW LED strip supports DC5V low voltage input, single LED can be cut, individually addressable, can be used with Raspberrypi/Arduino UNO development board or dream color LED controller to achieve precise color, mode and dynamic effect control for single LED, and can operate LED strip to achieve running horse It is widely used in bars, KTV and other entertainment places.

The addressable LED strip can not only mix RGB to produce 16 million kinds of dynamic effects, but also can produce individual white light, with a wide range of white light options (warm white 3000K; daylight white 6000K), and can be customized IP67 waterproof LED strip for outdoor decorative lighting.

For the SK6812 RGB+natural white 4000K type, the MOQ is 100 meters. 

SK6812 Chips Specifications Download     

LED Strip Light Feature

• Addressable RGB(WW/NW/DW) optional

• Single LED cuttable(individually addressable)

• SK6812 built-in drive IC 

• 24 bits data transmission

• 5.5mm/0.22in ultra-narrow 

• 18LEDs/Ft LED strip light

• 16 millions dream color chasing effect

• DC5V low voltage input

• 256 gray adjustment

• Customized IP67 waterproof rating

Standards and Certifications

Specifications

Similar to WS2812B LED strip, the SK2812 led strip has 3 wires for sending data - one V+ pin, one GND pin, and one data pin. That means you need 3 pins to control strip. Because the data is separated, you can use any processor speed or type to control these strips. an addressable RGB LED strip is a long flexible strand of LEDs each of which can be individually set to a certain color (hence: addressable). By varying the level of red, green and blue (RGB) per LED many color combinations can be made you can use any processor speed or type to control these strips, you can use any microcontroller or microprocessor, including Arduino, Raspberry Pi, BeagleBone, Propeller, SparkCore, and any 'raw' microcontrollers/microprocessors to control the strip. 

This strip comes as a single full meter with a 3-pin JST SM connector on each end. Every LEDs segment can be cut. Solder to the 0.1" copper pads and you're good to go.you can also connect strips together to make them longer. To power this strip, you need a 5V power supply.